top of page
Multi-split system
production of aesthetic models, from 3D printing to complete prostheses
Thanks to the multisplit system, you always get an aesthetically practical removable model.
Benefits of facebow articulation
Models made with multisplit can be articulated without any problem. . .
. . . because the V2ASplit-Cast plate is only 0.8 mm thick.
While the base plaster sets, articulation takes place - this saves time - only cut the model afterwards.
Important!
Always remove the magnet before trimming the model!
It is best to clean the self-isolating cuff under running water. Clean the multisplit plate only with water and a toothbrush or briefly with a jet of steam.
work only with low expansion knuckle plaster
Do not scratch or bend the multisplit panel
Do not clean the multisplit parts in the ultrasonic device
handle magnets with care due to their very strong adhesive force
How do I remove knuckle plaster from a finished job?
Note: Which articulates cleanly - saves time when cleaning!
Soak the multisplit plate with joint plaster for about 5 minutes - then simply remove the plate - done!
Our accessories for your plaster models
bottom of page